Dish 612C Uživatelská příručka stáhnout pdf (Strana 113)

Connections and Setup

105

Connecting to Your Dish Antenna

CONNECTING TO YOUR DISH ANTENNA

1 Before you can begin connecting your receiver to your dish antenna, you must first

complete the preceding sections to connecting your TVs to the receiver.

2 Connect two RG-6 coaxial cables between the SATELLITE IN 1 and SATELLITE IN 2 ports on

the receiver’s back panel to two available ports on either the switch, DISH Pro Plus

Separator, or LNBF in your existing system.

Note: If you are installing your receiver into a system with DISH Pro or DISH Pro Plus

LNBFs (and/or switches), you can have as much as 200 feet of cable between the LNBF

and the receiver. However, you must use only RG-6 coaxial cables rated up to at least

2150 MHz. Some cables may say “Swept tested for 2150 MHz.” If you have any doubt

about this, ask your DISH retailer, or look on the container the cable came in. Do not use

cable company TV cables or cables from other satellite TV systems not rated up to at least

2150 MHz. These other cables may cause signal loss. Do not use existing cables such as

RG-59. Use waterproof F-connectors outdoors.

3 Peel off the blue stickers and affix them to the cables close to where they connect to the

ATELLITE IN 1 and SATELLITE IN 2 connections on the back of the receiver. The stickers

are in the front cover of this guide.

4 On the DISH remote control, press MENU, select System Setup, Installation, and then

Point Dish to display the Point Dish screen on the TV.

5 Select Check Switch. Select Test.

6 The receiver begins performing the Check Switch tests. When it is finished, the Installation

Summary screen displays.

7 Make sure that the information on the Installation Summary screen identifies your system

correctly and shows all transponders for all satellites in your system.

8 Select OK.

9 Select Cancel to exit the Point Dish menu. At this point, the receiver may walk you

through a procedure to download software. If this prompt displays, follow the instructions

and do not disturb the receiver until the TV is displaying video from DISH. Otherwise,

press VIEW LIVE TV. After a few minutes, you should be watching TV.

1-2

SATELLITE IN SATELLITE IN

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 154 155

Žádné komentáře

Dish 612C Uživatelská příručka Strana 113