Dish 612C Uživatelská příručka Strana 125

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 155
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 124
Connections and Setup
117
Using Troubleshooting Tools
Point Dish and Check Switch
The Point Dish and Check Switch screens are often helpful to DISH Customer Service
Representatives. You may be asked to display these screens when you contact DISH.
Even though there are items that can be changed, only change them when specifically
directed to do so when speaking to a DISH Customer Service Representative.
Warning: Running the Check Switch test while the receiver has low or no signal
will result in incorrect receiver settings and cause you to lose channels. Do not run
a Check Switch test unless directed to do so by a DISH Customer Service
Representative or authorized technician’s instructions.
1 Press the MENU button on the receiver front panel or remote control.
2 Select System Setup.
3 Select Installation.
4 Finally, select Point Dish. This screen shows you information to help maximize your
satellite TV signal. The bar at the bottom of the screen indicates the signal strength. Green
shows a good signal, yellow is a marginal signal, and red indicates the signal is not
acceptable or is from the wrong satellite transponder or orbital location.
1
2
3
Press
MENU
Select System Setup then
Installation and then Point Dish
MENU
System Setup
6
Installation
1
Point Dish
1
The Point Dish screen appears
Zobrazit stránku 124
1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 154 155

Komentáře k této Příručce

Žádné komentáře